|
|
Predator PREDATOR 10K ANTENNAS
Here is a single coil 10K with a 12" shaft that is designed to be mounted on rooftops, magnet mounts, headache racks, diesel car mirrors etc. Mounted in the proper place, this antenna will tune extremely low and and perform very well.
The predator 10K antenna is made up of three sections. It has a shaft, coil and a top piece. This is one of the advantages it has over most all other antennas. If any section is damaged, it can be replaced (unlike heavy guage welded antennas) without having to buy a whole new antenna. Here is a breakdown of a single coil antenna showing the three sections. The top piece, the coil and the shaft. The lower illustration shows some visible parts to these three sections that screw into the tubing. It takes 15 parts to complete a single coil antenna. Every part is cut and machined to a close tolerance and screwed together. There is nothing pressed or standing out on the outside. There are no stand offs to arc at high watts and volts. If you are thinking corrosion, forget it. All metal parts that screw into each other are treated with a special electrical contact lubricant made especially for aluminum to prevent corrosion caused by moisture.
|
|
Send mail to webmaster@kdcsound.com with questions or comments about this web site. Last modified: May 21, 2004 |